ASSEMBLY AND SETUP
Use the following procedures to unpack and assemble your STAR TRAC TOTAL BODY TRAINER.
TOOLS REQUIRED
■Hex (Allen) Key,
■Hex (Allen) Key, 5 mm
■Screwdriver, Phillips #2
UNPACKING AND ASSEMBLY
1. Unpack the Shipping Carton
Remove the top and sides of the shipping carton.
Remove the display box and upper body arms and set aside
Remove the remaining foam packing inserts and the protective bagging from the
TOTAL BODY TRAINER.
Step 1
2. Install the Display
Using a #2 Phillips screwdriver, remove the back cover from the display by removing six #8 X 1/2” screws. RETAIN THE SCREWS.
While holding the display in position near the neck of the TOTAL BODY TRAINER, route the display cable connector through the cutout in the display mounting bracket.
Step 2A
Slide the display mounting bracket onto the neck of the TOTAL BODY TRAINER until the four holes in the bracket are aligned with the holes in the neck.
NOTE: Be sure not to pinch the display cable under the mounting bracket.
Step 2B
STAR TRAC TOTAL BODY TRAINER OWNER’S MANUAL | 11 |