Zadro Products TRANQUIL SOUNDS OXYGEN BAR manual Maintenance, Cleaning Condensation Chamber

Page 9

2After the blowing ends, the heat dispelling fan will continue to run for 3 minutes to drive away hot air. The machine will then turn off automatically. Turn the power switch off if you are not going to use it within a short time.

3If the unit will not be used for a period of time, remove the power cord from electrical outlet.

Maintenance

Exhaust gas vent

Danger

Turn off the unit and remove the Power Cord from the electrical outlet before maintenance to avoid electrical shock.

A Cleaning Condensation

Chamber

1 In areas of high humidity, during

 

 

operation, water vapor will condense

 

 

and therefore, there is a condensation

 

 

chamber in the middle section of the

 

Accumulated water

external connection hose.

 

 

2 If water in the condensation chamber

Open

Close

exceeds 1/3, pour the water out by

 

 

gently twisting the condensation

 

 

chamber to open it.

 

 

3 Then lightly shake both the upper and

lower end of the condensation chamber and then re-assemble the condensation

chamber.

4If the water accumulation exceeds more than 1/2, it may cause water backflow and resulting water accumulation on the external connection hose.

5Sometimes excessive water will cause abnormal sounds generated by bubbles and this can be solved by clearing the accumulated water.

9

Image 9
Contents Ane Tranquil Sounds Oxygen Bar Table of ContentsBenefits of the Oxygen Bar IntroductionControl panel Diagram of Oxygen Bar and Control PanelProduct Information Safety InformationOperating Procedure OperationGetting started Music Selection Time SettingEnd of Operation Cycle Diagram HeadsetCleaning Condensation Chamber MaintenanceCleaning the Headset Tube and Headset Cleaning the CabinetChanging the Air Intake Filters Unit does not turn on TroubleshootingRev.03112011