Burley HP 4489 warranty Install Roll Bar and Cover

Page 8

Install Roll Bar and Cover

1.Locate the two roll-bar knobs in the hardware bag, and the tonneau cover.

2.Lay the cover over the side rails so that it is right side out and oriented so the end with “Burley” and “Nomad” is at the front of the trailer.

3.Next, slip one of the roll-bar knobs through one of the grommets on the cover. Slide roll bar through the casing in the top of the mesh divider.

4.Align one end of the roll bar with its corresponding hole on the side rail. Thread the roll-bar knob through one side rail, and tighten it into the roll bar (see illus- tration below).

5.Similarly, thread the second roll-bar knob through the other grommet on the cover, align the roll bar with the hole in the other side rail, and screw this roll-bar knob into the roll bar.

6.Carefully check that both roll-bar knobs are screwed tightly into the roll bar.

Complete the cover installation by pulling on one of the B-tabs and looping the rubber O-ring on the trailer frame as shown below. Finish this for each of the three remaining B-tab/O-rings. Additionally, ensure that the cover extends over the top of each side panel (see illustration below).

Side Rail

Roll Bar

Cover Grommet

Roll Bar Knob

Cover

Trailer Frame

8

B-tab

Burley Nomad Owner’s Instruction and Safety Manual

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Nomad Introduction When Loaning or Selling Your TrailerCongratulations Hardware Bag Contents and Tool List II. Attaching the WheelsIII. Install Rear Reflectors Wheel axle assembly inserts into hollow trailer axleIV. Setting Up and Folding Your Burley Nomad Install Side RailsBurley Nomad Owner’s Instruction and Safety Manual Install Tailgate and Splashguard Install Roll Bar and Cover Install Tongue Rotate Tongue into PlaceFolding Your Burley Nomad Installing the Safety FlagHitching Your Burley Nomad to the Bicycle Burley Nomad Owner’s Instruction and Safety Manual Fabric/Shell Care VI. Trailer Maintenance and CareHitch and Tongue Maintenance VII. Safety Guidelines Use a Well-Maintained Bicycle and TrailerLoading Your Trailer Starting and StoppingNo Headphones or Other Distractions Prevent Trailer Tip OverFit, Alert, Adult Pilot No Motorized VehiclesRide on Clean, Paved Surfaces Riding When It’s SlipperyAvoid Riding in Traffic Navigating Curbs, Stairs, and EscalatorsWear Helmets Proper Wheels and Tires are EssentialKnow Your Trailer Hitch Use Your FlagBefore Each Ride, Ensure the Following VIII. Safety ChecklistsMonthly Checklist IX. Parts Lists & Drawings 2524 Burley Trailer Limited Warranty About Burley Design Cooperative
Top Page Image Contents