Burley Solo ST, d'lite ST manual Using Seat Recliner, Hitching Trailer to Your Bicycle

Page 10
Figures 7 & 8
Figure 6 or

Using Seat Recliner

For added comfort when children are sleeping, make the following adjustments to recline seat:

1.Loosen tension on lower horizontal strap on seat back.

2.Loosen tension on helmet pocket straps on upper back of seat. Photo 16

3.To return seat to upright position, reverse steps 1 & 2, and make sure upper seat strap is also tightened securely.

IMPORTANT

UPPER SEAT STRAP SHOULD ALWAYS BE TIGHTENED

BEFORE TRAILERING.

PHOTO 16

Loosenfor Reclining

Tightento returnseat toupright position

Hitching Trailer to Your Bicycle

Note: The Burley Forged Standard Hitch is used for bicycles with either nutted axles quick release assemblies.

1.Remove axle nut or rear quick release lever assembly from bike.

2.Match hole on flat side of hitch upper arm to left (non- chain ring side) rear dropout hole, and place hitch flat against the dropout.

3.Loosely reassemble axle nut or quick release assembly through hitch, dropout and wheel. Racks, bags, or fittings should not interfere with hitch.

4.Slide flex connector between hitch side arms, and match holes.

5.Open retaining pin and insert through hitch and flex connector holes from above. Close retaining pin.

6.Tighten axle nut or tighten and close quick release lever, with lever pointing to rear of bike. A properly adjusted quick release lever should leave an imprint on your palm when the lever is rotated to the closed position. Verify that hitch is secure and cannot be rotated by hand.

7.Wrap safety strap twice around inside of chain stay. Fasten hook to D-ring on underside of tow bar end. Figure 8

8.To remove trailer from bicycle, unfasten clip from D-ring and remove retaining pin.

WARNING

QUICKRELEASELEVERMUSTBEINCLOSEDPOSITIONAND HITCHSAFETYSTRAPPROPERLYINSTALLED.NUTTEDAXLES MUSTBETIGHTENEDSECURELY.HITCHMUSTNOTINTERFERE WITHRACKS,BAGSORFITTINGS.INSPECTHITCHANDTOWBAR FREQUENTLYFORDAMAGEORLOOSEFASTENERS.DAMAGEDOR IMPROPERLYINSTALLEDHITCHESORINTERFERINGPARTSCAN CAUSE ACCIDENTS RESULTING IN SERIOUS INJURY.

Nut Hitch

Figure 6: Nutted axle assembly

Safety strap wrappedtwice aroundchainstay

FlexConnector

Figure 8

Nut

QuickRelease Hitch

Figure 7: Quick release assembly

HitchUpperArm

QuickReleaseLever

RetainingPin

Hookfastenedto

D-ringundertowbar

10B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N UA L

Image 10
Contents Child trailer Contents Parts Bag Contents CongratulationsInstalling Tow Bar Clamps Opening and Closing Your TrailerAttaching the Seat Attaching WheelsUsing Parking Brake Installing Tow BarUsing Your Stroller Adjusting Stroller Wheel TrackingInstalling Safety Flag Installing CoverAttaching Handle Installing Shoulder Harness and Crotch Strap Pads Installing Seat PadsUsing Seat Harness Using Seat Recliner Hitching Trailer to Your BicycleSafety Checklists Maintenance and Storage2009d’liteST&SoloSTReplacementPartsandDiagram Solo Cover Page Page Burley Trailer Limited Warranty R L E Y D E S I G N