Using Your Stroller

1.Loop tether around handle bar center, slide strap end through small loop on other end of strap and tighten securely. Photo 9

2.Engage parking brake.

3.Place stroller wheel in “Stroll” position and secure by tightening knob. Photo 10

4.Slide tow bar into left tow bar mount as far as it will go and then close clamp firmly, making sure clamp latch is engaged.

Photo 11

Note: Retaining pin is not used for the “Stroll” position.

5.Push trailer to test stroller wheel tracking. If trailer does not roll straight, adjust wheel tracking.

To view a video clip of “Convert from Trailering to Strolling” go to: www.burley.com/support/tutorials.cfm.

Adjusting Stroller Wheel Tracking

Note: For best results, adjust with trailer fully loaded.

Tool Required: 5mm hex wrench (provided), 25mm (1”) wrench

1.With stroller wheel secured in “Stroll” position, loosen bolt using 5mm hex wrench. Figure 3

2.Using a 25mm wrench, turn bushing so that stroller wheel is vertical when viewed from front.

3.Fine tune as necessary so that trailer rolls straight.

4.Tighten bolt.

To view a video clip of “Adjusting Stroller Tracking” go to: www.burley.com/support/tutorials.cfm.

WARNING

WHENCONVERTINGTHISATTACHMENTFROMSTROLLINGTO BIKING, MAKE SURE THAT STROLLER WHEEL IS IN PROPER POSITIONBEFOREATTACHINGTRAILERTOYOURBICYCLE.

WARNING

THISPRODUCTWASDESIGNEDFORUSEONSURFACESTHATARE MEANTFORWALKING.DONOTUSEITONSTAIRS,ESCALATORS OROTHERUNEVENSURFACES.NEVERUSEITWITHINLINEOR ROLLERSKATES.FAILURETOFOLLOWTHESEINSTRUCTIONSCAN CAUSE AN ACCIDENT RESULTING IN SERIOUS INJURY.

Photo 9

Knob

Photo10:Strollerwheelin“Stroll”position

TowBar

	Tow Bar	Tow Bar
		Clamp
	Mount

Photo 11: Tow bar in “Stroll” position

Bolt

Bushing

figure3:Toadjuststrollerwheeltracking

B U R L E Y D ’ L I T E S T A N D S O LO S T O W N E R ’ S I N S T R U C T I O N A N D S A F E T Y M A N UA L