Bushnell 4.5-30X50, 3.5-21X50 manual Horizontal Crosshair

Page 21

The Horizontal Crosshair

On the horizontal crosshair, numerically designated Mil markings extend from the center of the crosshairs outward to the right in 2 Mil increments. To keep the reticle plane clean, the numbers were removed on the left side of the reticle but the reference points coincide with the markings from the right side of the crosshair. Moving from the center point to the right in the picture below measurements are as follows: .5 Mil, 1 Mil, 1.5 Mil, 2 Mil…etc.

1 Mil from center

1 Mil from center

.5 Mil from center
	.5 Mil from center

21

Image 21

Contents Proud USA Company Page Table of Contents Parts Guide Power Change Ring Windage Turret SunshadePower Change Ring Fast Focus EyepieceSide Focus Step Elevation and Windage TurretsSpecial Note Scopes Equipped with the Z-Lok elevation turret Setting a Zero Stop Z-StopModels Only Setting a Zero Stop Z-Stop Models Only Resetting the Zero Stop Z-Stop Models Only Page Bore Sighting and Zeroing the Scope First Focal Plane Reticle Bushnell Mil Dot Reticle Mils at Yards Equations Using the Mil Dot Reticle for RangingConverting Trajectory Data to Mil Holdovers Distance Trajectory Mil Size Actual Holdover Federal .308 168-gr Bthp Holdovers for a Mil-Dot ReticleYards Mil value Using the Mil Dot Reticle for HoldoverBushnell G2DMR Reticle Horizontal Crosshair Mil consisting Ten .1 mil marks VerticAL Crosshair Calculating Holds for Elevation Horus Vision H59 ReticleCalculating Holds for Moving Targets Horus Vision TRMR2 Reticle Page 3mph Calculating for MoversHorizontal Stadia Reticle from 10TH MIL to 38TH MIL Down on Vertical StadiaStorage MaintenanceElite Lifetime Limited Warranty Bushnell Outdoor Products Cody, Overland Park, Kansas 800