5.Attach the Seat (3) to the Seat Tube (5) with the two 1/4" x 2" Screws (17). Be sure that the Seat is oriented as shown.
3
6.Apply a small amount of grease to the two indicated shafts of the Pedal Frame (7). Slide a Pedal (12) onto the right shaft. Make sure that the Pedal is turned so the plastic tube is facing the Pedal Frame, as shown. Using the included pedal tool, tap a 1F2"Push Nut (30) onto the
end of the shaft. Be sure that the Push Nut is turned as |
| Plastic | |
shown in the inset drawing. |
| ||
|
| ||
Attach the other Pedal (12) (not shown) to the left shaft |
|
| |
of the Pedal Frame (7) in the same manner. |
|
| |
Note: Extra 1/2" Push Nuts (30) may have been includ- | t2 |
| |
ed. Save the Push Nuts and the pedal tool in case | Pedal | ||
replacement Push Nuts are needed in the future. | |||
|
|
Tool
7. Before using the CARDIO FORCE, check the Magnet (18) and the Reed Switch (15), Pivot the Pedal Frame
(7) until the Magnet is aligned with the Reed Switch (see the inset drawing). Loosen the indicated #8 x 3/4" Screw (27). Adjust the position of the Reed Switch so that there is a 1/8" gap between the Magnet and the Reed Switch. Retighten the Screw.
Make sure that all parts of the CARDIO FORCE are propedy tightened.
5