ASSEMBLY INSTRUCTIONS
LEFT |
|
L | Look down from the top |
| Pivot Tube |
| Shaft |
| R |
| Pivot Tube |
| RIGHT |
STEP 8: There is an "L" decal on the LEFT HANDLEBAR(8), and an "R" decal on the RIGHT HANDLEBAR
(9). To assemble the RIGHT HANDLEBAR(9), place a SPACER(51) and a LARGE WASHER(M16)(52) on the right side of the SHAFT on the UPRIGHT(6). Slide the RIGHT HANDLEBAR(9) onto the SHAFT and secure with a LARGE WASHER(M8)(45), LOCK WASHER(M8)(89), and BUTTON HEAD BOLT (M8x1.25x20mm)(66). Repeat on the left side.
STEP 9: Attach the LOWER PIVOTING ARMS(10) to the LEFT and RIGHT HANDLEBARS(8, 9) with HEX BOLTS(M6x1x35mm)(72), ARC WASHERS(M6)(86), LOCK WASHERS(M6)(88), and ACORN NUTS (M6x1)(84). Attach the LOWER PIVOTING ARMS(10) to the LINKAGES(11) on the PEDAL ARMS(4, 5) at both sides with the PLASTIC WASHERS(M8)(49), BUTTON HEAD BOLTS(M8x1.25x48mm)(67), and
NYLOCK NUTS(M8x1.25)(81).
STEP 10: Look down from the top of the UPRIGHT(6) to make sure the PIVOT TUBES on the HANDLEBARS(8, 9) are parallel to the FRONT STABILIZER(2) and the PEDAL ARMS(4, 5) are crossing the ROLLERS(58) properly. Tighten the BUTTON HEAD BOLTS(M8x1.25x15mm)(65) on the UPRIGHT(6) from STEP 5 on page 8.
10