ASSEMBLY INSTRUCTIONS
Metal Fitting |
Cable End |
Bracket |
Spring Hook |
STEP 3
Refer to the inset drawing. Lay the UPRIGHT(6) on the floor close to the front of the MAIN FRAME(1). Set the TENSION KNOB(25) on the UPRIGHT(6) at position 8, so the CABLE END of the TENSION KNOB KNOB(25) extends out of the metal fitting as far as possible. Connect the CABLE END of the TENSION KNOB(25) to the SPRING HOOK end of the TENSION CABLE(24). Pull the CABLE END on the TENSION KNOB(25) firmly and insert the cable through the slot in the bracket. Then insert the metal fitting on the end of the CABLE END of the TENSION KNOB(25) into the hole at the end of the slot in the BRACKET. Adjust the TENSION KNOB(25) and verify that the SPRING HOOK moves when the TENSION KNOB(25) is adjusted.
STEP 4
Plug the SENSOR WIRE(30) firmly into the CONNECTION WIRE(29). CAUTION: Be careful not to damage the SENSOR WIRE(30) and CONNECTION WIRE(29) when assembling the UPRIGHT(6).
STEP 5
Insert the UPRIGHT(6) onto the MAIN FRAME(1) and secure with BUTTON HEAD BOLTS(M8x1.25x15mm) (65), ARC WASHERS(M8)(87), and LOCK WASHERS(M8)(89). Do not tighten the bolts until STEP 10.
8