SET UP INSTRUCTIONS
Place the SpaceMate E300 in the area where it will be used. It is recommended that the SpaceMate E300 be placed on an equipment mat. The maximum operation dimensions of the SpaceMate E300 are approximately 34 3/4" long x 23 1/8" wide x 54 3/8" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 5.5 feet long is required for safe operation of the SpaceMate
E300. Make sure that adequate space is available for access to and passage around the SpaceMate
E300.
LEVELING: 1. Adjust the LEVELING CAPS(44) on the REAR STABILIZER(3) so that the SpaceMate E300 sets on the floor without rocking.
2.Adjust the STAND(46) on the FRONT STABILIZER(2) so that the stand touches the equipment mat or floor. Refer to the inset drawing.
MOVING: Grasp the pivot tubes on the HANDLEBARS(81, 82) and REAR STABILIZER(3) to move the SpaceMate E300, two people are required for moving. Do not use the Pedal Arms to move the SpaceMate E300. The Pedal Arms will move and may pinch your hand or fingers.
Grasp here to move
Grasp here to move
| Equipment Mat |
FUNCTION INSPECTION: |
|
Visually inspect the SpaceMate | E300 to verify that assembly is as shown in the above illustration. Check |
the function of the SpaceMate | E300. Stand on the foot pedals and place your hands at a comfortable |
position on the handlebars. Slowly move your highest foot forward and follow the natural path of the machine. Complete one full revolution slowly to verify that the drive train functions properly. Adjust the TENSION KNOB(21) and verify that it functions properly.
CAUTION: Locate and read the WARNING LABEL(85) on the SpaceMate E300. Make sure that all users read the WARNING LABEL(85).
11