ASSEMBLY INSTRUCTIONS
L |
L |
R |
R |
STEP 4
NOTE: 1. There is an "L" decal on the LEFT PEDAL ARM(4), and an "R" decal on the RIGHT PEDAL
ARM(5).
2.The RIGHT PEDAL SHAFT(34) has right hand threads and is tightened by turning clockwise. The LEFT PEDAL SHAFT(33) has left hand threads and is tightened by turning counter clockwise.
Place the front end of the RIGHT PEDAL ARM(5) on the ROLLER(39). Connect the back end of the RIGHT PEDAL ARM(5) to the RIGHT CRANK(31) located inside the CRANK DISK(28) as shown. Thread the RIGHT PEDAL SHAFT(34) into the RIGHT CRANK(31) and tighten securely. Repeat on the left side.
STEP 5
There is an "L" decal on the LEFT PEDAL CAP(37), and an "R" decal on the RIGHT PEDAL CAP(38). Attach the RIGHT PEDAL CAP(38) to the RIGHT PEDAL ARM(5) with ROUND HEAD BOLTS (M6x1x43mm)(52). Repeat on the left side.
NOTE: The LEFT and RIGHT PEDAL CAPS(37, 38) have a raised lip on two sides. Attach the LEFT and RIGHT PEDAL CAPS(37, 38) to the LEFT and RIGHT PEDAL ARMS(4, 5) so the raised lip is on the front and the inner side.
7