12
EVO XCEL ELLIPTICAL TRAINER
ASSEMBLY
STEP 4:
NOTE: Before attaching the Upright Post Assembly plug the Upper Computer Wire (81) into the Lower Computer Wire (82) as shown.
Attach upright post assembly. Insert the Upright Support (52) into the Main Frame (27). Insert and slightly tighten the four
M8 x 22mm Allen Head Bolts (70), Spring Washers (84) and Curved Washers (45). Align the Upright Support (52) so that the crossbar is parallel with the Front Stabilizer (74) then fully tighten the M8 x 22mm Allen Head Bolts (70).
Insert one Action Arm Shaft (55) into the Right Dual Action Arm (53) as shown. Attach the Right Dual Action Arm (53) to the Right Foot Pedal Tube (77) using one M10 x 88mm Carriage Bolt (66), M10 x 20mm Washer (85) and M8 Nylon Nut (44). Do not over tighten the nut, as this joint needs to pivot freely. Insert one 38mm Nut Cover (63) over the M8 Nylon Nut (44). Repeat this procedure to attach the Left Dual Action Arm (51) to the Left Foot Pedal Tube (60).
Visit us at: www.evofitness.com