INTRODUCTION IMPORTANT
PRECAUTIONS
ASSEMBLY
BEFORE
YOU BEGIN
ELLIPTICAL
OPERATION
CONDITIONING TROUBLESHOOTING LIMITED
GUIDELINES & MAINTENANCE WARRANTY
10
A S S E M B LY STEP 4 |
|
PEDAL ARM |
|
PEDAL ARM COVER | SCREW (J) |
SCREW (K) |
|
ROLLER WHEEL COVER |
|
A)Open HARDWARE BAG FOR STEP 4.
B)Attach the PEDAL ARM COVER using 1 SCREW (J).
C)Attach the ROLLER WHEEL COVER using 1 SCREW (K).
D)Repeat on other side.
HARDWARE BAG FOR STEP 4 CONTENTS :
SCREW (J) | SCREW (K) |
15 mm | 12 mm |
Qty: 2 | Qty: 2 |
A S S E M B LY STEP 5 |
UPPER HANDLEBAR |
CONSOLE MAST |
LOWER HANDLEBAR |
NOTE: There is NO hardware bag for this step. All hardware is
A)Remove PRE-ATTACHED BOLTS and WASHERS from CONSOLE MAST.
B)Slide right LOWER HANDLEBAR on CONSOLE MAST and attach by reinserting
C)Remove PRE-ATTACHED SET SCREWS from right UPPER HANDLEBAR
D)Slide right UPPER HANDLEBAR onto LOWER HANDLEBAR and secure by reinserting
E)Repeat on other side.
After handlebars are assembled they will rotate freely – be cautious. Until the machine is fully assembled, do not grab the handlebars for support.
11
IMPORTANT PRECAUTIONS INTRODUCTION
ASSEMBLY
BEFORE YOU BEGIN
ELLIPTICAL OPERATION
LIMITED TROUBLESHOOTING CONDITIONING WARRANTY & MAINTENANCE GUIDELINES
6/13/07 1:26:28 PM |