Precor UBK 800 warranty Connecting the Television Cable, To connect the television cable

26	Assembling and Maintaining UBK 800-Series Upright Exercise Bikes
	Cable	Connector Type	Circuit
			Connector
			Location
	Heart rate sensors	Four-contact strip, keyed
	Safety key	Six-contact strip, keyed
	(treadmills only)
	CSAFE	Eight-contact modular, on
		flat gray cable
	Auto Stop sensor	Four-contact strip, keyed
	(treadmills only)

To simplify installation and maintenance, route and connect cables 1 through 5 according to the following instructions.

Note: In the illustrations in this section, some cables are omitted for the sake of clarity.

Connecting the Television Cable

The console’s television tuner is mounted inside the console’s back plate. The tuner includes a short cable adapter that allows the television cable to be connected outside the back plate.

To connect the television cable:

1.Pull the cable out through the lower right corner of the back plate.

2.Route the cable counterclockwise around the outside of the back plate.

3.Attach the connector on the cable to the connector on the tuner cable and tighten the two connectors securely using two ⁷₁₆-inch open-end wrenches. Position both connectors above the upper right corner of the back plate.

4.Use a plastic tie to secure the connectors to the top of the back plate. Pass the tie through the two small holes near the upper right corner of the back plate, then wrap it around the connectors and tighten it securely. Cut off and remove the protruding end of the tie.