Whenkey. the program is finished, remove

8 Follow your progress with the LED track and the four displays.

See step 5 on page 10.

9 Measure your pulse, if desired.

See step 6 on page 11.

10 Whenkey. the program is finished, remove the

Step onto the foot rails and remove the key from the console. Keep the key in a secure place.

Note: If the displays and various indicators on the console remain lit after the key is removed, the console is in the “demo” mode. Refer to the instructions below and turn off the demo mode.

When you are finished using the treadmill, move the on/off switch near the power cord to the off position.

THE INFORMATION MODE/DEMO MODE

The console features an information mode that keeps track of the total number of hours that the treadmill has been operated and the total number of miles that the walking belt has moved. The information mode also allows you to switch the console from miles per hour to kilometers per hour.

To select the information mode, hold down the START/STOP button while inserting the key into the console. When the information mode is selected, the following information will be shown:

The DISTANCE/LAPS display will show the total number of miles that the walking belt has moved.

The TIME/MIN-MILE dis- play will show the total num- ber of hours the treadmill has been used.

An “E,” for english miles, or an “M,” for metric kilometers, will appear in the SPEED display. Press the SPEED ▲ button to change the unit of measurement.

IMPORTANT: The CALS./

FAT CALS./PULSE display

should be blank. If a “d” ap- pears in the display, the con- sole is in the “demo” mode.

This mode is intended to be used only when a treadmill is displayed in a store. When the console is in the demo mode, the power cord can be plugged in, the key can be removed from the console, and the displays and indica- tors on the console will auto-

matically light in a preset sequence, although the but- tons on the console will not operate. If a “d” appears in the CALS./FAT CALS./PULSE display when the in- formation mode is selected, press the SPEED ▼ button so the CALS./FAT CALS./PULSE display is blank.

To exit the information mode, remove the key from the console.