ProForm PCTL51901 user manual Extension Legs 103 remain in the Uprights

3.Slide the upper end of a Handrail (85) into the right Upright (82) as shown. Note: It will be necessary to pivot the Handrail to the side and back repeatedly (see arrow A) while pushing on the Handrail (see arrow B) to slide it fully into the Upright. Next, pivot the lower end of the Handrail down, push it toward the right Upright, and then align it with the indicated hole.

Slide the other Handrail (85) into the left Upright (82) as described above.

4.With the help of a second person, carefully tip the Uprights (82) down as shown. Make sure that the

Extension Legs (103) remain in the Uprights.

Tighten a Handrail Bolt (78) with a Handrail Washer (36) into each Extension Leg (103) and Handrail (85) as shown. It may be helpful to pull the Handrail (85) to the side and hand tighten a Handrail Bolt (78) into the bot- tom of the Handrail. Notice the angle of the Bolt. Attach the Bolt and Washer at the observed angle. It should be close to the same the angle of the Handrail (see inset drawing).

Note: Refer to figure 4b. To align the hole in the Handrail with the hole in the Extension Leg, it may be necessary to move the Handrails up or down or have a second person stand on the treadmill and lift the Handrail.

Next, attach each Extension Leg (103) with two Short Screws (101) as shown.

Note: One replacement Base Pad (97) may be included. Use the extra Pad if one becomes worn or needs to be replaced.

With the help of a second person, carefully tip the Uprights (82) back to the upright position.

3
		B
	82	85
			82
	85
		A
			Hole
4		97
82			82
			101
			36
82		85	78
		103	97
85		101
103			78
		36	85
		78
		97	36
4b

5.Make sure that all parts are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet

from damage, place a mat under the treadmill. 7