JVC RX-668VBK manual Adjusting the 3D-PHONIC Modes, Adjusting DAP Digital Acoustic Processor Modes

Adjusting the 3D-PHONIC Modes

Before you start, remember...

•Make sure that you have set the speaker information correctly (see page 11).

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.

Adjusting DAP (Digital Acoustic

Processor) Modes

Before you start, remember...

• Make sure that you have set the speaker information correctly

(see page 11).

• There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step 1 again.

On the front panel:

1. Press SURROUND repeatedly until “3D ACTION” or “3D THEATER,” appears on the display.

SURROUND

• You can only adjust the rear speaker output level when you have

connected the rear speakers and have set “REAR SPK” to “YES.”

See page 11.

On the front panel:

1. Press SURROUND repeatedly

The 3D-PHONIC, DSP, PRO LOGIC and the selected 3D- PHONIC mode indicators also light up on the display.

2. Press ADJUST so that the cursor	ADJUST
control %/ Þ/ @/ #buttons work
for adjusting the surround setting.

3. Press cursor control % / Þ repeatedly until “DSP EFFECT” appears on the display.

4. Press cursor control @/ #to select an effect level you want.

• Each time you press the button, the effect level changes as follows:

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5	DSP EFFECT 4
As the number increases, the selected 3D-PHONIC mode
becomes stronger.
From the remote control:	SOUND
	CONTROL

1. Press SOUND CONTROL.

The 10 keys are activated for sound adjustments.

2. Press SURROUND repeatedly	SURROUND
until “3D ACTION” or “3D	3
THEATER,” appears on the
display.

The 3D-PHONIC, DSP, PRO LOGIC and the selected 3D- PHONIC mode indicators also light up on the display.

3. Press EFFECT to select an effect	EFFECT
level you want.	4

•Each time you press the button, the effect level changes as follows:

DSP EFFECT 1 DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, the selected 3D-PHONIC mode becomes stronger.

SURROUND

until the DAP mode — LIVE CLUB, DANCE CLUB, HALL, or PAVILION — appears on the display.

The DSP and the selected DAP mode indicators also light up on the display.

2. Press ADJUST so that the cursor	ADJUST
control % / Þ/ @/ #buttons work
for adjusting the DSP setting.

3. Press cursor control %/ Þ repeatedly until “REAR LEVEL” appears on the display.

4. Press cursor control @/ #to adjust the rear speaker output level (from –10 to +10).

Note:

You cannot adjust the left and right rear speaker output levels separately.

5. Press cursor control %/ Þ repeatedly until “DSP EFFECT” appears on the display.

6. Press cursor control @/ #to select an effect level you want.

• Each time you press the button, the effect level changes as follows:

DSP EFFECT 1DSP EFFECT 2 DSP EFFECT 3

DSP EFFECT 5 DSP EFFECT 4

As the number increases, the selected DAP mode becomes stronger.

17