5.Hold the Console Base (47) near the Left Handrail (71). Cut the plastic tie off the ends of the indicated ground wires. Attach the ends of the ground wires to the indi- cated small hole in the Left Handrail with the Silver Ground Screw (75).
6.Touch the Right Handrail(72) to dischargeany static. Slide the sleeve off the connector on the Upright Wire (42) as shown in the inset drawing. Next, press the end of the Upright Wire into the socket in the bottom of the Console Base (47). The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connec- tor and then insert it. Then, slide the sleeve back over the connector.
7.Set the Console Base (47) on the Handrails (71, 72). Attach the Console Base with four 3/4” Screws (2). Start all four Screws before tightening them; do not over- tighten the Screws.
See the lower drawing. Make sure that the Upright
Wire (42) is routed below the two indicated round posts (A). Next, press the Upright Wire into the slot be- tween the square post (B) and the Console Base (47).
8
5 |
| Ground |
|
|
|
| |
| 47 | Wires |
|
|
|
| |
Small |
|
| |
Hole | 75 |
| |
71 |
|
| |
|
|
| |
6 |
|
|
|
72 |
|
|
|
|
| 42 | 47 |
42 | Sleeve | Connector |
|
|
|
| |
7 |
| 47 | 71 |
72 |
|
| |
2 |
|
| 2 |
|
|
| |
| A | B |
|
|
|
| |
42 | 47 |
|
|