TROUBLESHOOTING
Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please contact the establishment where you pur- chased your equipment.
PROBLEM: The power does not turn on
SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor | ||
is plugged into a properly grounded outlet (see page 10). Use only a | ||
sor that meets all of the specifications described on page 10. Important: The treadmill is not com- | ||
patible with |
|
|
b. After the power cord has been plugged in, make sure that the key is inserted into the console. | ||
c. Check the reset/off circuit breaker located on the | c |
|
treadmill frame near the power cord. If the switch |
| |
protrudes as shown, the circuit breaker has tripped. |
|
|
To reset the circuit breaker, wait for five minutes | Tripped | Reset |
and then press the switch back in. | ||
PROBLEM: The power turns off during use |
|
|
SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing | ||
| above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in. | |
| b. Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for | |
| five minutes, and then plug it back in. |
|
| c. Remove the key from the console. Reinsert the key into the console. | |
. | d. If the treadmill still will not run, please contact the establishment where you purchased your equip- | |
ment. |
| |
PROBLEM: The displays of the console do not function properly |
| |
SOLUTION: a. Remove the key from the console and UNPLUG THE | a | |
| POWER CORD. Remove the Screws (77) from the | |
| Hood (1), and carefully pivot the Hood off. | 77 |
|
| 1 |
Locate the Reed Switch (10) and the Magnet (18) on the left side of the Pulley (17). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 3 mm (1/8 in.). If necessary, loosen the Screw (58), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood, and run the treadmill for a few minutes to check for a cor- rect speed reading.
3 mm | 17 |
58 | |
10 | 18 |
Top |
|
View |
|
25