Assembly

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver and rubber mallet .

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the	1
treadmill to the upright position.	1
treadmill to the upright position.
While a second person tips the treadmill to one side
and holds it, insert one of the Extension Legs (102) into
the treadmill as shown. Make sure that the Extension
Leg is turned so the Base Pad (99) is on the bottom.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs			102
(102) are resting flat on the floor.			102
(102) are resting flat on the floor.
			99
2. With the help of a second person, carefully lower the	2
treadmill frame and then tip the Uprights (69) down as	2
treadmill frame and then tip the Uprights (69) down as
shown. Make sure that the Extension Legs (102) remain
in the Uprights.
Tighten two 3/4Ó Screws (100) into each Upright (69) and		99
Tighten two 3/4Ó Screws (100) into each Upright (69) and
Extension Leg (102).		Frame
With the help of a second person, carefully tip the			69
Uprights (69) back to the vertical position.			69
	69		100
	69		102
			102
	99	100
	99	102
		102
3. Using the included allen wrench, tighten the Pulse Bar	3
Bolt (78) on each side of the treadmill.	3
Bolt (78) on each side of the treadmill.
Find the plastic tie inside the post on the right Upright (69).		76
		67	78
Insert the plastic tie through a Handrail Extension (66) and		67
		Holes

insert the Handrail Extension into the post as shown. Make
insert the Handrail Extension into the post as shown. Make		Cutout
sure that the indicated holes are on top. Tap the Handrail			69
Extension with a rubber mallet to fully insert it. Attach the		75	69

Handrail Extension with two 1/2Ó Screws (67) as shown.
Handrail Extension with two 1/2Ó Screws (67) as shown.		66	Post
			Post

Identify the Right Foam Grip (75), which has a cutout in the		Tie
left side for the Pulse Bar (76). Slide the Right Foam Grip as
far as possible onto the post on the right Upright (69).