ASSEMBLY
To hire an authorized service technician to assemble the treadmill, call
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex keys | and your own Phillips screwdriver | and | |
rubber mallet | . |
|
|
Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST on pages 22 and 23. The number after the parentheses shows the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
Extension Leg Nut | Front Endcap | 1" Tek Screw | Handrail Bolt | ||
Screw |
|
|
| ||
|
|
|
|
| |
Screw | 2 1/4" Extension Leg Bolt | 2 1/2" Extension Leg Bolt | |||
1. Make sure that the power cord is unplugged. | 1 |
|
|
| |
With the help of a second person, carefully tip |
| 14 |
the treadmill onto its left side as shown. Partially | 84 | |
fold the Frame (58) so the treadmill is more sta- |
|
|
ble. Do not fully fold the Frame until the |
| 44 |
treadmill is completely assembled. |
|
|
Insert an Extension Leg (89) into the base of the | 92 |
|
Upright (84). Hold an Extension Leg Nut (67) in | 89 |
|
the bottom of the Extension Leg, and thread a |
| |
|
| |
2 1/4" Extension Leg Bolt (92) into the top of the |
|
|
Extension Leg. Next, thread a 2 1/2" Extension |
|
|
Leg Bolt (65) into the bottom of the Extension | 67 |
|
Leg. Firmly tighten the Extension Leg Bolts. | 65 | |
Slide a Front Endcap (44) onto the base of the | 58 |
|
Upright (84). Partially tighten a Front Endcap |
| |
|
| |
Screw (14) into the Front Endcap and the base. |
|
|
| 6 |
|