ProForm PFTL57507.0 user manual Wire

Page 8

5.Attach the Latch Housing (73) to the left Upright (84) with two Screws (3); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.

Remove the knob from the pin. Make sure that the collar and the spring are on the pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the pin into the Latch Housing (73). Then, tighten the knob onto the pin.

5

84

73

Knob

Spring

3

Collar

Large Hole

Pin

6.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the large hex key is used to adjust the walking belt (see page 20).

If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the receiver included with the chest pulse sensor.

1.Make sure that the power cord is unplugged. Remove the indicated Screw (3) and the Access Door (76) from the back side of the Console Base (85).

2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (85). Hold the re- ceiver so the small cylinder is oriented as shown and is facing the Console Back. Attach the receiver to the plastic posts on the Access Door (76) with the two included small screws.

3.Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (3). Discard the other wires included with the receiver.

 

Wire

85

 

 

Small

76

Screws

 

 

3

 

Small

 

Cylinder

 

A

8

Image 8
Contents Call TOLL-FREE QUESTIONS?Model No. PFTL57507.0 Serial No Table of Contents Important Precautions Page Back Before YOU BeginRight Side Leg. Firmly tighten the Extension Leg Bolts AssemblyMake sure that the power cord is unplugged Extension Leg. Firmly tighten the Extension Leg Bolts Wire PRE-LUBRICATED Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeTurn on the fan if desired Follow your progress with the displayMeasure your heart rate if desired HOW to USE a Calorie Program Press the Start button to start the programHOW to USE a Cross Training Program Select a cross training programPerform the first strength exercise when prompted Continue the cross training programInformation Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageTemperatures above 85 F 30 C HOW to Move the TreadmillHOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Exercise Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR0607A Qty DescriptionDescription 101 33 Explodeddrawing Exploded Drawing B-Model No. PFTL57507.0 R0607A Exploded Drawing C-Model No. PFTL57507.0 R0607A Exploded Drawing D-Model No. PFTL57507.0 R0607A Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty