13. Align the holes in the Left Base Leg Cover (33) | 13 | 83 |
|
|
with the holes in the Base (37). Note: It may be |
|
| ||
|
|
| ||
necessary to press on the Left Base Leg Cover to |
|
|
|
|
align the holes. |
|
|
|
|
Attach the Left Base Leg Cover (33) with three |
|
|
|
|
1/2" Screws (83). Be careful not to overtighten |
|
|
|
|
the Screws. |
|
|
|
|
|
| 83 |
|
|
|
| 33 | 37 |
|
|
|
|
| |
|
| 83 |
|
|
14. Tighten a 1/2" Screw (83) into each side of the | 14 |
|
|
|
Base (37) and each Base Leg Cover (33, 42). Be |
|
|
| |
|
|
|
| |
careful not to overtighten the Screws. |
|
|
|
|
Remove the plastic packaging from the bottom of |
|
|
|
|
the Belly Pan (49). |
|
|
|
|
|
|
| 37 |
|
| 49 |
|
|
|
|
|
| 83 |
|
| 33 |
|
| 42 |
15. Carefully raise the Uprights (38, 39). | 15 |
|
|
|
|
|
|
| |
Attach the Latch Housing (91) to the Left Upright |
|
|
|
|
(38) with two 3/4” Screws (3). Make sure that |
|
|
|
|
the large hole in the Latch Housing is on the |
|
|
|
|
side shown. Do not overtighten the Screws. |
|
|
|
|
Remove the knob from the pin. Make sure that |
| 91 | 38 |
|
the collar and the spring are on the pin. Insert |
| Knob |
|
|
the pin into the Latch Housing (91), and tighten |
|
|
| |
|
| Large | 39 | |
the knob back onto the pin. |
|
| ||
|
| Hole |
| |
|
|
|
| |
16. Make sure that all parts are properly tight- |
| 3 |
|
|
|
|
|
| |
ened before you use the treadmill. Note: Extra |
| Spring | Pin |
|
hardware may be included. Keep the included |
|
|
| |
|
|
|
| |
hex keys in a secure place; the large hex key is |
| Collar |
|
|
used to adjust the walking belt (see page 20). To |
|
|
|
|
protect the floor or carpet, place a mat under the |
|
|
|
|
treadmill. |
|
|
|
|
| 11 |
|
|
|