ProForm PFTL49406.1 user manual

Page 4

19.Never leave the treadmill unattended while it is running. Always remove the key, unplug the power cord, and switch the reset/off cir- cuit breaker to the off position when the treadmill is not in use. (See the drawing on page 5 for the location of the circuit breaker.)

20.Do not attempt to raise, lower, or move the treadmill until it is properly assembled. (See ASSEMBLY on page 6, and HOW TO FOLD AND MOVE THE TREADMILL on page 20.) You must be able to safely lift 45 pounds (20 kg) to raise, lower, or move the treadmill.

21.When folding or moving the treadmill, make sure that the storage latch is fully closed.

22.Never insert any object into any opening on the treadmill.

23.Inspect and properly tighten all parts of the treadmill regularly.

24.DANGER: Always unplug the power cord immediately after use, before cleaning the treadmill, and before performing the mainte- nance and adjustment procedures described in this manual. Never remove the motor hood un- less instructed to do so by an authorized ser- vice representative. Servicing other than the procedures in this manual should be performed by an authorized service representative only.

25.This treadmill is intended for in-home use only. Do not use this treadmill in a commer- cial, rental, or institutional setting.

WARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product.

SAVE THESE INSTRUCTIONS

The decals shown here have been placed on the treadmill. If a decal is missing, or if it is illegible, call the toll-free tele- phone number on the front cover of this manual and order a free replacement decal. Apply the decal in the location shown.

4

Image 4
Contents Model No. PFTL49406.1 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Right Side Before YOU BeginBack Make sure that the power cord is unplugged AssemblyBolts yet Bolts yet See steps 2 and 4. Fully tighten the two Endcap Screws Tighten the Bolts yetConnectors properly see the inset draw Connectors are not ConnectedPinch any wires Pulse Bar Screws Firmly tighten the four 1 1/4 BoltsSide View Cover ScrewsView From Above Small HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeOn the foot Rails Measure your heart rate if desiredWhenkey. you are finished exercising, remove Select one of the preset programs HOW to USE a Preset ProgramInsert the key fully into the console HOW to USE a Heart Rate Program Select a heart rate programFollow your progress with the display Information MODE/DEMO Mode Optional Chest Pulse SensorHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Top Conditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Page R0507A Key Qty DescriptionDRAWING-Model Part 2 Part 3 Part 4 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT