SCAN
Your radio is equipped with the Scan feature, which allows you to monitor multiple channels/ talkgroups for voice activity. The radio will stop on a channel/talkgroup when it detects activity on it.
Your radio automatically switches to a channel/ talkgroup, within the scan list, when it detects activity.
•The LED indicator blinks green during scan mode; it stops blinking when the radio switches to an active channel/talkgroup.
There are two ways that your radio scans:
•System Scan (manual)
•Auto Scan (automatic)
TALKBACK
The Talkback feature allows you to respond to a transmission while scanning. If transmission is detected on a channel/talkgroup while scanning, the radio will stop on that channel/ talkgroup for a default period of time after activity has ceased. This is referred to as “hangtime”. During this hangtime you may respond by pressing the PTT button.
Note: The LED scan indicator stops blinking while the radio is in hangtime. If the PTT button is not pressed after the prepro- grammed hangtime, the radio returns to scanning channels/talkgroups.
START SYSTEM SCAN
Press the preprogrammed Scan button to start scanning channels/talkgroups in your scan list (if Auto Scan is not enabled) (see page 18).
STOP SYSTEM SCAN
Press the preprogrammed Scan button to stop System Scan (see page 17).
Note: Your dealer/programmer can preprogram your radio when exiting System Scan to automatically revert either to the last scan channel/talkgroup that had activity on it or to the channel/ talkgroup where scan was initiated.
START AUTO SCAN
Auto Scan automatically starts scanning once a channel/talkgroup with Auto Scan enabled is selected.
Select a channel/talkgroup that has been preprogrammed for Auto Scan by your dealer/ programmer.
27
SCAN
English
