8. While a second person holds the console as- | 8 | Console | |
sembly near the Pulse Bar (66), connect the | |||
| Assembly | ||
Console Ground Wire (107) on the Pulse Bar to |
| ||
|
| ||
the ground wire from the console assembly. |
|
| |
Connect the wire from the console assembly to | Ground | 75 | |
the Upright Wire (75). Make sure to connect | |||
the connectors properly (see the inset draw- | Wire |
| |
|
| ||
ing). The connectors should slide together |
|
| |
easily and snap into place. If the connectors |
|
| |
do not slide together easily and snap into place, |
| 107 | |
turn one connector and then try again. IF THE |
| ||
CONNECTORS ARE NOT CONNECTED |
| Wire | |
PROPERLY, THE CONSOLE MAY BE DAM- | 66 | 75 | |
AGED WHEN THE POWER IS TURNED ON. | |||
Lay the wires inside the bottom of the Pulse Bar |
| 76 | |
(66). |
| ||
|
| ||
9. Set the console assembly on the Left and Right | 9 |
| |
Uprights (70, 76). Be careful not to pinch any | Console Assembly | ||
| |||
wires. |
|
| |
Attach the console assembly to the Pulse Bar |
|
| |
(66) with six 3/4" Screws (23). Start all six |
|
| |
Screws before firmly tightening them. |
|
|
|
|
| 66 |
|
|
|
| 23 | 23 | 23 |
|
|
| 70 |
|
| 76 |
10. Identify the Left Handrail Cover (68), which has | 10 |
|
|
|
|
a LEFT sticker on it. Slide the Left Handrail | Console |
|
|
| |
|
|
|
| ||
Cover onto the left Handrail (62) and hold it |
| Assembly |
|
|
|
against the console assembly. Tighten two |
|
|
|
|
|
Cover Screws (52) into the Left Handrail Cover |
| 68 |
|
|
|
and the Left Upright (70); be careful not to |
|
|
|
| |
| 62 |
|
|
| |
overtighten the Cover Screws. |
|
|
|
| |
Attach the Right Handrail Cover (74) in the |
|
|
|
|
|
same way. |
|
|
|
|
|
|
| 52 | 70 |
|
|
|
|
|
| 74 | |
|
|
|
| 62 |
|
|
|
|
| 52 | 76 |
|
|
|
|
| |
| 9 |
|
|
|
|