ProForm PFTL590040 user manual Distance/Laps, Measure your heart rate, if desired

Page 12

Time/Incline/Segment Time display—When the manual mode or the iFIT.com mode is se- lected, this display will

show the elapsed time

and the incline level of the treadmill. The display will change from one number to the other every few seconds, as shown by the indicators beside the display. When a personal trainer program or a heart rate program is selected, the display will show the time remaining in the program, the time remaining in the current segment of the program, and the incline level. Note: Each time the incline changes, the display will show the current incline setting for several seconds.

Distance/Laps

display—This display shows the distance that you have walked or run and the number of 1/4- mile laps you have com-

pleted. The display will change from one number to the other every few seconds, as shown by the indicator beside the display.

Speed/Min-Mile display—This display shows the speed of the walking belt and your current pace (pace is

measured in minutes per

mile). The display will change from one number to the other every few seconds, as shown by the in- dicators beside the display. Note: Each time the speed changes, the display will show the current speed setting for several seconds.

Note: When the Km/H in- dicator is lit, the console will display speed and distance in kilometers; when the Km/H indicator

is not lit, the console will

display speed and distance in miles. To change the unit of measurement, first hold down the Stop button while inserting the key into the console. An “E” for English miles or an “M” for metric kilometers will appear in the display. Press the Speed but- ton to change the unit of measurement. When the desired unit of measurement is selected, remove the key and then reinsert it.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

6 Measure your heart rate, if desired.

Note: When using the pulse sensor, make sure that your hands are clean. The pulse sensor should also be kept clean with a damp cloth and mild detergent.

To measure your

heart rate, stand

on the foot rails and place both thumbs on the pulse sensors as shown. Do not press too hard, or the circulation in

your thumbs will be restricted and your pulse will not be detected. Next, wait until the heart- shaped indicator in the Calories/Fat Calories/Heart Rate display flashes steadily. After a few seconds, your heart rate will be shown. Hold your thumbs on the sensor for another 15 seconds for the most ac- curate reading.

If the displayed heart rate appears to be too high or too low, or if your heart rate is not displayed, lift your thumbs off the sensors and allow the display to reset. Then, place your thumbs on the sensors as described above. Try the pulse sensor several times until you become familiar with it. Remember to stand still while measuring your heart rate.

7 Whenkey. you are finished exercising, remove the

Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when the treadmill is folded to the storage posi- tion or the treadmill will be damaged. Next, re- move the key from the console and put it in a se- cure place. Note: If the displays and various indi- cators on the console remain lit after the key is removed, the console is in the “demo” mode. See page 21 and turn off the demo mode.

When you are finished using the treadmill, move the reset/off circuit breaker switch near the power cord to the off position and unplug the power cord.

12

Image 12
Contents QUESTIONS? Model No. PFTL590040 Serial NoCustomer HOT Line Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Important Precautions Page Before YOU Begin Left Side Right SideAssembly Harness 49 does not fall into the Right UprightPage Page Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual ModeSelect the manual mode Insert the key fully into the consoleDistance/Laps Measure your heart rate, if desiredWhenkey. you are finished exercising, remove HOW to USE Personal Trainer Programs Select one of the personal trainer programsHOW to USE Heart Rate Programs Adjust the maximum speed limit for Program Enter your ageHOW to Connect Your Portable Stereo HOW to Connect Your Home Stereo HOW to Connect Your ComputerHOW to Connect Your VCR Audio Adapter CableInsert the key into the console PressVCR. the Play button on your CD player orWhenkey. the program is completed, remove HOW to USE Programs Directly from OUR WEB Site When the program has ended, remove the keyFollow the on-line instructions to start Program Return to the treadmill and stand on the footInformation MODE/DEMO Mode Optional Chest Pulse SensorHOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Troubleshooting Problem The power turns off during useProblem The thumb pulse sensor does not function properly Problem The walking belt slows when walked on TopConditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencySuggested Stretches Part Identification Chart Part LIST-Model No. PFTL590040 Key Qty DescriptionExploded DRAWING-Model No. PFTL590040 R0105AOrdering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT