ProForm PFTL590040 specs

8. Attach the matching Left Bottom Handgrip (82) with three	8
1/2” Screws (33).	8
1/2” Screws (33).
Attach the Right Top Handgrip and the Right Bottom
Handgrip (not shown) as described above.				82
				82
		33
9. Attach a Wheel (58) to the right side of the Base (116)	9
with a Wheel Bolt (56) and a Nut (3) as shown.	9
with a Wheel Bolt (56) and a Nut (3) as shown.
Attach a Wheel to the left side of the Base (not shown) in
the same way.
		3		116
		3
		58		56
10. Carefully lower the Uprights (55, 64) as shown.	10	114	40	37
	10	114	40	37
Press the Console Back (40) onto the back of the				114
Console Base (38). Make sure that the Console Back	39			50
and the Console Base are mated correctly and that no				50
and the Console Base are mated correctly and that no
wires are pinched. Tighten two 1/2” Silver Screws (114)
into the indicated holes. Tighten 3/4” Screws (37) into the
other holes in the Console Back.
Make sure that the left side of the Left Upright (64) is flush
with the left side of the Base (116). Firmly tighten—but do				38
not overtighten—the two Upright Bolts (112) in the left side		55		38
		55		64
of the Base. Then, make sure that the Right Upright (55)				64
is flush with the right side of the Base. Tighten the two
Upright Bolts (not shown) in the right side of the Base.
Insert the Left and Right Cup Holders (39, 50) into the		37
large holes in the Console Base (38). If there is a small		37
hole under each Cup Holder, the two Small Clamps (117)
should be attached. See the inset drawing. Loop a Small
Clamp through the hole in the bottom of a Cup Holder and				112
attach it with a 3/4” Screw (37). Attach a Small Clamp to	117			116
the other Cup Holder in the same manner.	117
the other Cup Holder in the same manner.
Raise the Uprights (55, 64) back to the vertical position.

11.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 25).

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.To protect the floor or carpet from damage, place a mat under the treadmill.