5.Attach the Latch Housing (73) to the left Upright (84) with two Screws (3); start both Screws and then tighten them. Note: Make sure that the large hole in the Latch Housing is on the indicated side.
Remove the knob from the Latch Pin (21). Make sure that the collar and the spring are on the Latch Pin. (Note: If there are two collars, place one on each side of the spring.) Next, insert the Latch Pin into the Latch Housing (73). Then, tighten the knob onto the Latch Pin.
5 |
84 |
73 |
Knob |
Spring |
3 |
Collar |
Large Hole |
Latch |
Pin |
6.Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread- mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 20).
If you purchase the optional chest pulse sensor (see page 16), follow the steps below to install the receiver included with the chest pulse sensor.
1.Make sure that the power cord is unplugged. Remove the indicated Screw (3) and the Access Door (76) from the back side of the Console Base (85).
2.Connect the wire on the receiver (A) to the indicated wire extending from the Console Base (85). Hold the re- ceiver so that the small cylinder is oriented as shown and is facing the Console Back. Attach the re- ceiver to the plastic posts on the Access Door (76) with the two included small screws.
3.Make sure that no wires are pinched. Reattach the Access Door (76) with the Screw (3). Discard the other wires included with the receiver.
| Wire |
85 |
|
| Small |
76 | Screws |
| 3 |
| Small |
| Cylinder |
| A |
8