Before You Start
2Press the release button, slide and re- move the front panel toward you.
Take care not to grip it too tightly or to drop the front panel and protect it from contact with water or other fluids to prevent perma- nent damage.
Release button
3Put the front panel into provided pro- tective case for safe keeping.
Attaching the front panel
1Make sure the inner cover is closed.
2Replace the front panel by clipping it into place.
|
| Section |
|
| 01 |
|
| English |
Resetting the microprocessor | ||
The microprocessor must be reset under the following conditions:
!Prior to using this unit for the first time after installation
!If the unit fails to operate properly
!When strange or incorrect messages ap- pear on the display
%Press RESET with a pen tip or other pointed instrument.
RESET button
Switching the DSP setting mode
This unit features two operation modes: the 3- way network mode (NW) and the standard mode (STD). You can switch between modes as desired. Initially, the DSP setting is set to the standard mode (STD).
!After switching, reset the microprocessor.
WARNING
Do not use the unit in standard mode when a speaker system for
En | 9 |
