Audio Adjustments
4Select the position for the seat on which the microphone is placed.
Refer to Using the position selector on page
# If no position is selected before you start auto TA and EQ, Front Left is selected automatically.
5Press SOURCE and hold until the unit turns off.
6Press and hold EQ to enter the auto TA and EQ measurement mode.
The front panel opens automatically.
7Plug the microphone into the micro- phone input jack on this unit.
8Press
9Get out of the car and close the door within 10 seconds when the
The measurement tone (noise) is outputted from the speakers, and auto TA and EQ be-
gins.
# When all speakers are connected, auto TA
and EQ is completed in about six minutes.
# To stop auto TA and EQ, press
# To cancel auto TA and EQ part way through, press BAND.
10When auto TA and EQ is completed, Complete is displayed.
When correct measurement of car interior acoustic characteristics is not possible, an error message is displayed. (Refer to Under-
Section
12
standing auto TA and EQ error messages on | English |
| |
page 78.) |
|
11Press BAND to cancel the auto TA and EQ mode.
12Store the microphone carefully in the glove compartment.
Store the microphone carefully in the glove compartment or any other safe place. If the microphone is subjected to direct sunlight for an extended period, high temperatures may cause distortion, color change or malfunction.
Note
Make sure you have disconnected the micro- phone before pressing EJECT to open or close the panel (an alert sounds if the mic is still con- nected).
En 
69
