Onkyo HT-S5100 Controlling Other Components—Continued, Resetting the Remote Controller

Controlling Other Components—Continued

Remote Control Codes for Onkyo Components Connected via

Onkyo components that are connected via are con- trolled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.

1	Make sure the Onkyo component is con-
	nected with an	cable and an analog
	audio cable (RCA).
	See page 40 for details.
2	Enter the appropriate remote control code
	to the REMOTE MODE button.

•[DVD] REMOTE MODE button 31612: Onkyo DVD player with

•[CD] REMOTE MODE button 71327: Onkyo CD player with

•[TAPE] REMOTE MODE button

42157: Onkyo cassette recorder with (default)

See the previous page for how to enter remote control codes.

3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.

If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control

an Onkyo component that’s not connected via , use the following remote control codes:

•[DVD] REMOTE MODE button

30627: Onkyo DVD player without (default)

•[CD] REMOTE MODE button

71817: Onkyo CD player without (default)

Resetting the REMOTE MODE Buttons

You can reset a REMOTE MODE button to its default remote control code.

1	While holding down the REMOTE
	MODE button that you want to
	reset, press and hold down the
	[AUDIO] button until the Remote
	indicator lights up (about 3 sec-
	onds).

(3 seconds)

2	Within 30 seconds, press the
	REMOTE MODE button again.
	The Remote indicator flashes twice,
	indicating that the button has been
	reset.
	Each of the REMOTE MODE buttons
	is preprogrammed with a remote con-
	trol code. When a button is reset, its
	preprogrammed code is restored.

Resetting the Remote Controller

You can reset the remote controller to its default settings.

1	While holding down the
	[RECEIVER] REMOTE MODE but-
	ton, press and hold down the
	[AUDIO] button until the Remote
	indicator lights up (about 3 sec-
	onds).

(3 seconds)

2	Within 30 seconds, press the
	[RECEIVER] REMOTE MODE but-
	ton again.
	The Remote indicator flashes twice,
	indicating that the remote controller
	has been reset.

83