Listening to SIRIUS Satellite
SUB UPDATED
Displayed while your subscription is being updated. No operations can be performed until this message has cleared.
UPDATING XXX%
Displayed while the channel map is being updated. Wait until the updating is complete.
SIRIUS UPDATING
Displayed while the SiriusConnect receiver’s firmware is being updated.
INVALID CHANNEL
Displayed if you select an unavailable channel.
CALL SIRIUS
Displayed when you select a channel to which you are not subscribed. Call SIRIUS if you want to subscribe.
CHECK SR TUNER
Positioning the SiriusConnect Home Tuner
You can check the signal strength of the SIRIUS Satel- lite Radio signal and adjust the position of the Sirius- Connect Home antenna accordingly.
1 | Press the [RECEIVER] button, |
| |
Remote | followed by the [SETUP] button. |
controller |
|
Displayed if the SiriusConnect receiver is not con- nected. Make sure the SiriusConnect receiver is con- nected properly, and make sure its AC adapter is plugged in.
2
Remote
controller
Use the Up and Down []/[ ] buttons to select “8.ANT Aiming,” and then press [ENTER].
Note:
•If the 8. SAT RadioMode is set to None (see page 56), the “ANT Aim- ing” item is not available.
RECEIVER
ENTER
/ / /
SETUP
Number |
buttons |
3 | Adjust the position of the | ||
| |||
| indoor/outdoor antenna con- | ||
| nected to the SiriusConnect | ||
| receiver so that the satellite | ||
| (SAT) signal strength bar is as | ||
| long as possible. | ||
|
|
|
|
|
|
|
|
| If you cannot receive a satellite signal, | ||
| press the Down [ ] button to display | ||
| the terrestrial (TER) signal strength | ||
| meter and adjust your antenna so that | ||
| the bar is as long as possible. | ||
| Terrestrial signals are only available in | ||
| certain areas. | ||
|
|
|
|
|
|
|
|
| So long as the signal strength is good, | ||
| you can enjoy SIRIUS Satellite Radio | ||
| by using either satellite or terrestrial | ||
| reception. | ||
|
|
|
|
60