ProForm PFTL59200 user manual Assembly, A phillips screwdriver not included

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires a rubber mallet

and a phillips screwdriver (not included).

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1.With the help of a second person, carefully raise the Uprights (114) until the treadmill is in the position shown.

Remove the EKG decal from the right grip pulse and discard.

Note: One replacement Bumper (116) is included. If a Bumper becomes worn and needs to be replaced, use the replacement Bumper.

2.Using a rubber mallet, tap the Lock Knob Sleeve (91) into the large hole in the left Upright (114). Align the two small pins on the Lock Knob Spacer (75) with the small holes in the left side of the Upright. Insert the Lock Knob Spacer into the Upright. Make sure that the Lock Knob Sleeve and the Lock Knob Spacer are fully inserted into the Upright.

Remove the Lock Knob (90) from the Lock Pin (94). Make sure that the Lock Pin Collar (93) and the Spring

(92)are on the Lock Pin. Insert the Lock Pin into the left Upright (114) and tighten the Lock Knob onto it.

3.Observe the two Rear Feet (72) at the rear of the tread- mill (see figure 1 above). If there is a space between the right Rear Foot and the floor, the Foot Spacer (71) will need to be moved from the left Foot to the right Foot.

Hold the treadmill firmly with both hands, and raise the treadmill to the storage position as described on page 18.

Using a phillips screwdriver, remove the Screw (6), Rear Foot (72) and the Rear Foot Spacer (71) from the left side. Remove the Rear Foot from the right side. Snap the Rear Foot Spacer (71) onto the right Rear Foot. Reattach the Rear Feet to the treadmill Frame (79).

Hold the treadmill firmly with both hands, and lower the treadmill as described on page 18.

1
				Remove
		114		EKG
				decal
72			116
			72
2
	114
	91	92	94
	90
	75	93
3
			Ridges
	79
		71	72	6

4.Make sure that all parts of the treadmill are tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 20). To protect the floor or carpet from damage, place a mat under the treadmill.

6