9.Attach the Latch Assembly (37) and the Latch Spacer (39) to the Left Bottom Handgrip (40) with two Latch Screws (36). Firmly tighten the Latch Screws. Note: The ridge on the Latch Spacer must be on the side shown.
If there are plastic ties around the left and right Pulse Sensor Plates (2), cut off the plastic ties.
10.Attach the Hood Cover (3) to the treadmill with four 1/2” Screws (51). Firmly tighten the Screws.
Peel the backing off the Hood Decal (1). Position the Hood Decal over the recess in the Hood Cover (3). Press the Hood Decal into place.
Note: If the treadmill rocks slightly, tip the treadmill back onto its side. See step 2. Loosen the four Base Leg Bolts (77), adjust the positions of the Base Legs (78), and then retighten the Base Leg Bolts. Raise the treadmill back to the vertical position. Repeat until the rocking motion is eliminated.
To protect the floor or carpet from damage, place the in- cluded Mat (125) under the front of the treadmill.
11.Plug the Power Cord (93) into the front of the treadmill as shown.
Note: Extra parts may be included.
9 |
|
|
| Ridge |
|
| 39 | 2 |
| 40 | |
|
| |
| 37 |
|
|
| 36 |
10 |
| 1 |
|
| 3 |
|
| 51 |
|
| 125 |
11 |
|
|
|
| 93 |
12.Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 26). To protect the floor or carpet from damage, place a mat under the treadmill.
Note: The underside of the treadmill walking belt is coated with
9