JVC GVT0057-016A Recording a Tape on Deck B, On the unit only Press Eject 0 for the deck B

Recording

Continued

IMPORTANT:

•It may be unlawful to record or playback copyrighted material without the consent of the copyright owner.

•The recording level is automatically set correctly, so it is not affected by the VOLUME, the SUBWOOFER LEVEL, the SOUND MODE, and the DSP Surround controls. Thus, during recording you can adjust the sound you are actually listening to without affecting the recording level.

•If recordings you have made have excessive noise or static, the unit may be too close to a TV. Increase the distance between the TV and the unit.

•You can use type I tape for recording.

Recording a Tape on Deck B

On the unit ONLY:

1 Press EJECT 0 for the deck B.

To protect your recording

Cassettes have two small

tabs on the top to protect

from unexpected erasure or re-recording.

To protect your recording, remove these tabs.

To re-record on a protected tape, cover the holes with adhesive tape.

To keep the best recording and playback sound quality

If the heads, capstans, and pinch rollers of the cassette decks become dirty, the following will occur:

•Impaired sound quality

•Discontinuous sound

•Fading

•Incomplete erasure

•Difficulty in recording

To clean the heads, capstans, and pinch rollers

Use a cotton swab moistened with alcohol.

Pinch rollers

Capstans

2 Put a recordable cassette into deck B.

3 Close the cassette holder gently.

4 Start playing the source—FM, AM, DVD/SVCD/VCD/CD player, deck A, or auxiliary equipment connected to AUX jacks.

•When the source is SVCD, VCD or CD, you can also use SVCD/VCD/CD Direct Recording (see page 33) and Auto Edit Recording (see page 34).

•When the source is deck A, you can also use the dubbing method. (See “Dubbing Tapes” on page 33.)

5 Check the tape direction of deck B.

•If the tape direction is not correct, press TAPE 2 3 twice then 7to change the tape direction.

6 Press REC START/STOP.

The (recording) indicator lights up on the display and recording starts.

• If no cassette is inserted, “NO TAPE”

appears on the display. If a protected tape is inserted, “NO REC” appears on the display.

To stop recording immediately, press 7.

To remove the cassette, press EJECT 0for deck B.

Heads

To demagnetize the heads

Turn off the unit, and use a head demagnetizer (available at electronics and audio shops).

To record on both sides—Reverse Mode

Press REVERSE MODE so that the Reverse

Mode indicator lights up like— .

• When using the Reverse Mode for recording, start recording in the forward (3) direction

first. Otherwise, recording will stop when

recording is done only on one side (reverse) of the tape.

To cancel Reverse Mode, press the button again so that the

Reverse Mode indicator lights up like— .

– 32 –