ProForm 831.24723.2 user manual Assembly, Make sure that the power cord is unplugged

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor- mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included hex keys and your own Phillips screwdriver		and
adjustable wrench	.

Use the drawings below to identify the assembly hardware. The number in parentheses below each drawing is the key number of the part, from the PART LIST near the end of this manual. The number after the parentheses is the quantity needed for assembly. Note: If a part is not in the parts bag, check to see if it is preattached to one of the parts to be assembled. Extra hardware may be included. If a part is missing, call 1-888-533- 1333. To avoid damaging plastic parts, do not use power tools for assembly.

			1/2" Screw	M4 x 25mm
			(22)–1
M8 Star				Screw (2)–4
	M10 Star
Washer (10)–4
	Washer (8)–8
		Base Pad Spacer
		(104)–2	M4 x 19mm
			Screw (1)–6	M8 x 25mm Bolt (6)–4
1/4" Washer
(9)–4			1/4" x 3 1/2" Bolt (4)–4
Bolt Spacer (79)–4			M10 x 96mm Bolt (5)–4

1. Make sure that the power cord is unplugged.	1
With the help of a second person, carefully tip
			B
the treadmill onto its left side. Partially fold the
	Tie	77	A
Frame (48) so that the treadmill is more stable;
do not fully fold the Frame yet.			Hole
Remove and discard the two indicated bolts (A)	85		81
and the shipping bracket (B).	48		2
Cut the tie securing the Upright Wire (77) to the
Base (85). Locate the tie in the indicated hole in
the Base, and use the tie to pull the Upright Wire
out of the hole.
Attach a Base Pad (81) to the Base (85) in the	104	81
location shown with a Base Pad Spacer (104)		2
and an M4 x 25mm Screw (2). Then, attach an-
other Base Pad (81) with only a Screw (2).
	6