ProForm 831.293041 specification

6.Place the Console Base (47) on the Right Handrail (72) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (2) (only two Screws are shown). Do not overtighten the Screws.

Insert the Wire Harness (42) through the two indicated plastic ties on the Console Base (47). Next, touch the Right Handrail (72) to discharge any static. Refer to the inset drawing. Find the 3-wire connector on the end of the Wire Harness (42). Insert the connector into the red socket beneath the console. The connector should slide easily into the socket and “snap” into place. If the connector does not slide easily and snap into place, turn the connec- tor and then insert it. Insert the 5-wire connector into the black socket beneath the console in the same way.

Make sure that the connectors and wires appear as shown at the right. IF THE CONNECTORS ARE NOT

INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

If you plan to use iFIT.com CDs or videocassettes, or pro- grams from our Web site (see page 13), plug the Audio Cable (120) into the jack on the back of the Console (43).

7.Insert the excess Wire Harness (42) into the large hole in the side of the Right Handrail (72). Securely tighten the plastic ties on the bottom of the Console Base (47) to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties.

Route the Wire Harness (42) through the indicated open- ing in the Console Base (47). If you connected the Audio Cable (120) in step 5, route it through the slot in the Wire Cover (44). Attach the Wire Cover to the Console Base with a 1/2” Silver Screw (48).

Tighten two 3/4” Screws (2) into the Console Base (47).

Refer to step 3 and 4. Firmly tighten the three 3/4” Bolts (37) in each Handrail (72, 71).

8.Attach a Wheel (66) to the inner side of each Extension Leg (63) with a Wheel Bolt (64) and a Wheel Nut (13) as shown. Do not overtighten the Bolts. The Wheels should be able to spin freely.

6
	47
		42
	Ties
2	72	120	43
		42
		3-wire		5-wire
				5-wire
				120
7
Ties	42	Opening		47
Ties	42	Opening
				44
72
	120
		48		2
				2
8
13				63
13
	66			64

9.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.