ProForm 831.293032 user manual Assembly, Rubber mallet Wire cutters, Ension Leg 63 in the same way

ASSEMBLY

Assembly requires two persons.Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

Assembly requires the included allen wrenches		and your own phillips screwdriver	,
rubber mallet	, wire cutters	, and needlenose pliers	.

To identify small parts, use the PART IDENTIFICATION CHART attached in the center of this manual.

1.Make sure that the power cord is unplugged.

1 69

With the help of a second person, carefully raise the		62
Uprights (69) until the treadmill is in the position shown.		63
Insert one of the Extension Legs (63) into the treadmill
as shown. (Note: It may be helpful to tip the Uprights as
you insert the Extension Leg.) Make sure that the
Warning Decal (62) is on the indicated side of the
Extension Leg.
Insert the other Ext	ension Leg (63) in the same way.

2.With the help of a second person, carefully lower the treadmill frame and then tip the Uprights (69) down as shown. (Note: It may be helpful to place your foot on an

Extension Leg [63] as you tip the Uprights.)	Make sure
that the Extension Legs remain in the Uprights.
Attach each Extension Leg (63) with two 3/4” Tek
Screws (58).

Attach four Base Pads (57) with 3/4” Tek Screws (58) as shown.

Note: One replacement Base Pad (57) may be included. If a Base Pad becomes worn and needs to be replaced, use the replacement Base Pad.

2
57
58
58	58
		57
57	63
58
	58		69
		57	63
	58

5