ProForm 831.297680 user manual Assembly requires the included allen wrench, Phillips

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included allen wrench		, and your own adjustable wrench	, phillips
screwdriver	, and scissors	.

1. Refer to the drawing on page 4 and identify the left	1	92
side of the treadmill. With the help of a second person,			93
carefully lay the treadmill on its left side.
				70
Firmly slide an Extension Leg (99) into each side of the
Base (70) as shown. Make sure that the Extension Legs				99
are turned so the Base Pads (89) are on the indicated				89
sides. Using the included Allen Wrench (92), attach each
Extension Leg with an Extension Screw (93).
With the help of a second person, carefully raise the
treadmill to the vertical position so both Extension Legs
(99) are resting flat on the floor.
				99
		93		89
2. Remove the four Screws (4) from the left Upright (70).	2
Without removing the tape from the Latch Bracket (60)		70	60, 66
and Latch Spacer (66), hold the Latch Spacer against
the left Upright (70) as shown. Attach the Latch Bracket			69
and the Latch Spacer with the four Screws. Make sure
that the Screws are tight, but do not overtighten	4		66
them; if the Screws are overtightened, the Storage
				68
Latch (69) will not slide smoothly. After the Latch
Bracket is attached, remove any visible tape.
Note: The inset drawing shows how the Latch Bracket
(60), Latch Springs (68), Storage Latch (69), and Latch			60	69
Spacer (66) fit together.
3. Remove the indicated Screw (4) from the treadmill	3
Frame (1). Attach the plastic Catch (5) to the Frame with
the Screw. Note: It may be necessary to slide the
Storage Latch (69) to the left while attaching the Catch.
		1
		69		5
		4

5