Chest Pulse Sensor TROUBLE-SHOOTING

When the cool-down period is completed, the walk-		FITNESS TEST will end, and the TIME/PACE
ing belt will slow to a stop. Your fitness level will		display will show a fitness level of 0 (FL 00). (See
then be shown in the		CHEST PULSE SENSOR TROUBLE-SHOOTING
TIME/PACE display.		on page 7.)
TIME/PACE display.		on page 7.)
There are ten fitness
levels—fitness level 10		Note: The FITNESS TEST program cannot be
(FL 10) is the highest.		stopped for a moment and then restarted. However,
(FL 10) is the highest.		stopped for a moment and then restarted. However,
Remember, the		the program can be stopped at any time by press-
Remember, the		the program can be stopped at any time by press-
FITNESS TEST is		ing the STOP button. The TIME/PACE display will
intended only to indicate the relative fitness level		then show an estimated fitness level.
you have attained.
		When the program is completed, remove the key.
Note: The SPEED and INCLINE buttons will not	6
Note: The SPEED and INCLINE buttons will not
function while the FITNESS TEST program is		Step onto the foot rails. Make sure that the incline
running. If your heart rate is not detected during the		of the treadmill is set at 1.5%. Remove the key
program, the letters “PLS” will flash in the CALS./		from the console. Store the key in a secure place. In
FAT CALS./PULSE display. If your heart rate is not		addition, press the on/off switch to the “off” position.
detected during the last thirty seconds of any 4-		(See the drawing on page 11.)
minute period (after 4 minutes, after 8 minutes,
etc.), the walking belt will slow to a stop, the

of the treadmill is set at 1.5%. Remove the key