Locate the Reed Switch (24) and the Magnet (18) on the left side of the Pulley (120). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8”. If necessary, loosen the Screw (25), move the Reed Switch slightly, and then retighten the Screw. Reattach the Hood (not shown). Make sure that the Screws are returned to the correct holes (see drawing A). Run on the treadmill for a few minutes to check for a correct speed reading.
PROBLEM: The walking belt slows when walked on
1/8” |
|
25 | 120 |
| |
24 | 18 |
|
Top
View
SOLUTION: a. Use only a
b. If the walking belt is overtightened, treadmill perfor- | b | |
mance may decrease and the walking belt may be | ||
permanently damaged. Remove the key and UN- |
|
|
PLUG THE POWER CORD. Using the included allen |
|
|
wrench, turn both rear roller adjustment bolts counter- |
|
|
clockwise 1/4 of a turn. When the walking belt is prop- |
|
|
erly tightened, you should be able to lift the edges of |
|
|
the walking belt 3 to 4 inches off the walking platform. |
|
|
Be careful to keep the walking belt centered. Plug in | Rear Roller Adjustment Bolts | |
the power cord, insert the key, and run the treadmill | ||
for a few minutes. Repeat until the walking belt is |
|
|
properly tightened. |
|
|
c. If the walking belt still slows when walked on, please call | ||
|
| |
PROBLEM: The walking belt is
SOLUTION: a. If the walking belt is
a
b. If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the allen wrench, turn both rear roller bolts clockwise 1/4 of a turn. When the walking belt is correctly tight- ened, you should be able to lift each side of the walk- ing belt 3 to 4 inches off the walking platform. Be careful to keep the walking belt centered. Plug in the power cord, insert the key, and walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.
b
27