ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included allen wrenches | and your own phillips screwdriver | , | |
and wire cutters | . |
|
|
For help identifying assembly hardware, see the drawings below. Note: The assembly hardware and other small parts are packaged in separate part bags. If a part is not found in the part bags, check to see if the part has been preattached. If a part is missing, call
3/4” Screw | 3/4” Tek Screw | 1/4” Star Washer | |
| Wheel Nut | ||
| |||
|
| ||
Wheel Bolt | 5/16” x 1” Bolt | 1/4” x 1” Bolt | |
| |||
| 4” Bolt |
|
1.With the help of a second person, carefully raise the Uprights (109) to the position shown.
Insert one of the Extension Legs (128) into the treadmill as shown. Make sure that the Extension Leg is turned so the Base Pad (100) is beneath it. Note: It may be helpful to tip the Uprights (109) forward as you insert the Extension Leg.
Insert the other Extension Leg (not shown) in the same way.
Attach a Wheel (108) to each Wheel Housing (106) (only one is shown) with a Wheel Bolt (107) and a Wheel Nut (21). Make sure that the Wheel Bolts are inserted from the sides shown. Do not overtighten the Wheel Bolts.
1 | 109 |
|
|
| |
107 | 108 |
|
| 21 |
|
| 21 | 108 |
| 106 | 107 |
| 128 |
|
| 100 |
|
6