HOW TO USE PROGRAMS DIRECTLY FROM OUR WEB SITE
Our Web site at www.iFIT.com allows you to access basic programs, audio programs, and video programs directly from the internet. Additional options are soon to be available. See www.iFIT.com for details.
To use programs from our Web site, the treadmill must be connected to your home computer. See HOW TO CONNECT YOUR COMPUTER on page 14. In addition, you must have an internet connection and an internet service provider. A list of specific system requirements will be found on our Web site.
Follow the steps below to use a program from our Web site.
1 Insert the key into the console.
See HOW TO TURN ON THE POWER on page 10.
2 Select the iFIT.com mode.
When the key is in- serted, the manual
mode will be selected and the manual indica-
tor will light. To use a program from our Web
site, press the Mode button repeatedly until the iFIT.com indicator lights.
3 Go to your computer and start an internet connection.
4 Start your Web browser, if necessary, and go to our Web site at www.iFIT.com.
5 Follow the desired links on our Web site to se- lect a program.
Read and follow the
6 Follow the on-line instructions to start the program.
When you start the program, an
7 Return to the treadmill and stand on the foot rails. Find the clip attached to the key, and slide the clip onto the waistband of your clothes.
When the
During the program, an electronic “chirping” sound will alert you when the speed of the treadmill is about to change. CAUTION: Always listen for the “chirp” and be prepared for speed changes.
If the speed setting is too high or too low, you can manually override the setting at any time by pressing the Speed buttons on the console.
However, when the next “chirp” is heard, the speed will change to the next setting for the program.
To stop the walking belt at any time, press the Stop button on the console. The Time display will begin to flash. To restart the program, press the Start button or the Speed ▲ button. After a mo- ment, the walking belt will begin to move at 1.0 mph. When the next “chirp” is heard, the speed will change to the next setting for the program.
When the program is completed, the walking belt will stop and the Time display will begin to flash. Note: To use another program, press the Stop button and go to step 5.
Note: If the speed of the treadmill does not change when a “chirp” is heard, make sure the iFIT.com indicator is lit and the Time display is not flashing. In addition, make sure that the audio cable is properly connected, that it is fully plugged in, and that it is not wrapped around a power cord.
8 Follow your progress with the LED track and the four displays.
See step 5 on page 10.
9 Measure your heart rate if desired.
See step 6 on page 11.
10 When the program ends, remove the key.
See step 6 on page 12.
17