ProForm DRTL13720 Assembly requires your own phillips screw, Driver Rubber mallet, Large

ASSEMBLY

Assembly requires two people.		Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials		until assembly is completed.	Assembly requires your own phillips screw-
driver	and	rubber mallet	.

Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

1. With the help of a second person, carefully raise the						1
	treadmill to the upright position as shown.
	Insert one of the Extension Legs (102) into the treadmill
	as shown. Make sure that the Extension Leg is turned
	so the Base Pad (99) is on the bottom. If necessary, tip
	the Uprights (69) forward as you insert the Extension							69
	Leg.
	Insert the other Extension Leg (not shown) in the same
	way.
									102
									99
2. With the help of a second person, carefully lower the						2
	treadmill frame and then tip the Uprights (69) down as
	shown.	Make sure that the Extension Legs (102) remain
	in the Uprights.
	Attach each Extension Leg (102) with two of the six 3/4”						99
	Screws (100) as shown.						Frame
	With the help of a second person, carefully tip the								69
	Uprights (69) back to the vertical position.
						69			100
	Note: One replacement Base Pad (99) may be included.								102
	Use the extra Base Pad if one becomes worn or needs to					99	100
	be replaced.
							102
3.	Insert a Handrail Extension (66) into the				post on the right	3
	Upright (69) as shown;			make sure that the indicated
	holes are on top.		Tap the Handrail Extension with a rub-				76		81
	ber mallet to fully insert it. Attach the Handrail Extension
								67
							Tab
	with two 1/2”		Screws (67) as shown.
								Holes
							Cutout
	Identify the Right Foam Grip (75), which has a				large	cutout
	in the left side for the Pulse Bar (76). Slide the Right Foam						75		69
	Grip as far as possible onto the post on the right Upright
									Post
	(69). (Note: It may be helpful to apply soapy water to the							66
	Handrail Extension [66].)			Make sure that the tab on the
	Foam Grip is inserted into the Console Base (81).
						6