3Start the walking belt.
After you have moved the speed control to the RESET position, slowly slide it upward until the walking belt begins to move at slow speed.
Carefully step onto the walking belt and begin ex- ercising. Change the speed of the walking belt as desired by sliding the speed control.
To stop the walking belt, step onto the foot rails and slide the speed control to the RESET position.
4Adjust the incline of the treadmill as desired.
To change the incline of the treadmill, press the top or bottom of the in- cline control until the desired incline level is reached.
5Follow your progress with the four displays.
SPEED displayÑThis display shows the speed of the walking belt, in miles per hour.
TIME displayÑThis display shows the elapsed time.
DISTANCE displayÑ This display shows the distance that you have walked or run, in miles.
CALS/FAT CALS |
|
|
|
|
|
|
|
|
|
|
|
| Arrow |
|
|
| |
PULSE displayÑThis |
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
display shows the ap- |
|
|
|
|
|
|
|
|
proximate numbers of |
|
|
|
|
|
|
|
|
calories and fat calories |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
you have burned. (See |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
| |
FAT BURNING on page |
|
|
|
|
|
|
|
|
14.) Every seven seconds, the display will change | ||||||||
from one number to the other. Arrows in the dis- | ||||||||
play will indicate which number is currently shown. | ||||||||
Note: This display also shows your pulse when the pulse sensor is used.
To reset the displays at any time, press the ON/RESET button.
6 Measure your pulse, if desired.
To measure your pulse,
Sensors
stand on the foot rails and place both thumbs
on the pulse sensors as shown. The pulse sen-
sors are pressure acti- vatedÑfully press them
down. Do not press too hard, or the circu- lation in your thumbs will be restricted, and your pulse will not be detected. Next, raise
your thumbs slightly
Indicator
until the
indicator in the pulse display flashes steadily. Hold your
thumbs at this level. After a few seconds,
three dashes will appear in the display and your pulse will be shown. Hold your thumbs on the sen- sor for another 15 seconds for the most accurate reading.
If the displayed pulse appears to be too high or too low, or if your pulse is not displayed, lift your thumbs off the sensors and allow the display to reset. Press down again on the sensors as de- scribed above.
Make sure that your thumbs are positioned as shown, and that you are applying the proper amount of pressure. Try the pulse sensor several times until you become familiar with it. Remember to stand still while measuring your pulse.
7When you are finished exercising, stop the walking belt and remove the key.
Step onto the foot rails, stop the walking belt and remove the key from the console. The displays will turn off about five minutes after the key is removed.
Note: To conserve the batteries, the displays will automatically turn off any time that the walking belt is stopped and the ON/RESET button is not pressed for five minutes.
9