JVC RX-5032VSL, RX-6032VSL Creating Realistic Sound Fields, Using Surround Modes, Press Surround

Creating Realistic Sound Fields

Make sure that you have set the speaker information correctly (see pages 15 and 16).

•If only the front speakers are connected, you cannot use Surround/DSP modes.

•You cannot use DSP modes if no surround speakers are connected.

•Do not change the speaker setting while using any Surround/DSP modes; otherwise, the Surround/DSP modes may be canceled when you deactivate the speakers required for the Surround/DSP modes.

RX-6030VBK and RX-6032VSL only:

•When DVD MULTI is selected as the source, you cannot use Surround/DSP modes (SURROUND and DSP buttons do not work).

Front panel								Remote control
DSP	SURROUND								DISPLAY MODE
			RX–6030V	AUDIO/VIDEO CONTROL RECEIVER					DSP
STANDBY
	SURROUND						DIMMER
STANDBY/ON
	DSP						INPUT DIGITAL		SURROUND/DSP
	SURROUND/DSP							SURROUND
	OFF						INPUT ANALOG		OFF
							INPUT ATT
	DVD MULTI	DVD	VCR	TV SOUND	CDTAPE/CDR	FM	AM
					SOURCE NAME
PHONES	SPEAKERS	SUBWOOFER OUT	FM/AM TUNING		FM/AM RESET	FM MODE	MEMORY
	ON/OFF	ON/OFF

REMOTE CONTROL

SURROUND/DSP OFF

Using Surround Modes

Speaker layouts required for Surround modes are as follows:

• 5 channels

(Front, center, and surround speakers are connected.)

• 4 channels

(Front and surround speakers are connected.)

• 3 channels

(Front and center speakers are connected.)

7Operating procedure

1Select the source you want to listen to and start playing.

•When playing back software encoded with Dolby Digital and DTS Digital Surround, select the digital input mode (see page 17).

2Press SURROUND.

The appropriate Surround mode will be activated according to the incoming signal.

•DOLBY DIGITAL:

Activated if you are playing back multi-channel software encoded with Dolby Digital.

•DTS SURROUND:

Activated if you are playing back software encoded with DTS Digital Surround.

•PL II MUSIC* or PL II MOVIE:

Activated if you are playing back any software other than the above. (The last one selected will be activated.)

The PRO LOGIC II indicator lights up on the display.

Press SURROUND repeatedly to select the one appropriate for the source.

*When “PL II MUSIC” is selected, you can select Panorama control to enjoy “wraparound” sound effect with side-wall image (see page 19 for the setting procedure).

Notes:

•When “DOLBY DIGITAL” or “DTS SURROUND” is selected with no surround speakers connected, the surround sounds are downmixed and output from the front speakers.

•For the available Surround modes according to the input signals, see “Available Surround/DSP modes for each input signal” on page 25.

To adjust the speaker output level and select Panorama control for Pro Logic II Music, see pages 19 to 21.

The adjustment is memorized for each source (except for Panorama control).

To turn off Surround mode, press SURROUND/DSP OFF.

26