3.With the help of a second person, set the Console Base
(6)on the Right Handrail (32) and near the right Upright
(14)as shown.
Route the Wire Harness (26) through the bracket on the Right Handrail (32) as shown.
Refer to the inset drawing. Push the Strain Relief Clip (88) onto the Wire Harness. Insert a 3/4Ó Screw (30) into the Strain Relief Clip and into the indicated hole in the Right Handrail (32). Make sure that there is no slack in the Wire Harness between the Strain Relief Clip and the Console Base (6). Tighten the Screw into the Console Base.
IMPORTANT: The Strain Relief Clip (88) must be at- tached as instructed.
Feed the excess Wire Harness (26) into the right Upright (14). Next, insert the bracket on the Right Handrail (32) into the right Upright. Be careful not to pinch the Wire
Harness.
Feed all excess Wire Harness (26) down into the right Upright (14)
4.Attach the Console Base (6) to the Left and Right Handrails (2, 32) with three 3/4Ó Screws (30).
5.Thread a Handrail Bolt (15) with a Handrail Washer (16) into the right Upright (14) and the Right Handrail (32). Do not tighten the Handrail Bolt yet.
Attach the lower end of the Right Handrail (32) to the Extension Leg (41) with a 3 1/2Ó Handrail Bolt (89), a 3/8Ó Washer (99), and a Flange Nut (57).
Tighten all parts used in this step and in step 2.
6.Attach the Storage Latch (12) to the left Upright (14) with two 1/2Ó Screws (13). Be careful not to overtighten the Screws.
Refer to the inset drawing. Remove the backing from the Adhesive Clip (74). Press the Adhesive Clip onto the base of the Uprights (14) in the indicated location. Press the Allen Wrench (73) into the Adhesive Clip.
3 | 6 |
|
|
|
|
| |
Bracket |
|
| |
32 |
| 88 |
|
|
|
| |
| 26 | 30 |
|
|
|
| |
|
| 14 |
|
|
| 32 | 88 |
|
|
| |
|
|
| 6 |
|
| 26 | 30 |
|
|
| |
4 |
|
|
|
|
| 6 |
|
32 | 30 | 2 |
|
|
|
| 30 |
5 |
|
|
|
|
| 15 |
|
|
| 16 |
|
|
| 32 |
|
|
| 14 |
|
| 41 |
|
|
| 57 |
|
|
|
| 99 |
|
|
| 89 |
|
6 |
|
|
|
| 14 |
|
|
|
|
| 14 |
|
| 13 |
|
| 12 |
|
|
|
| 74 | 73 |
7.Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a mat under the treadmill.
6