ProForm 831.297771 user manual Assembly

Page 5

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench

and your own phillips screwdriver , adjustable wrench and scissors .

1.With the help of a second person, carefully raise the treadmill to the upright position. While a second person tips the treadmill to one side and holds it, insert one of the Extension Legs (103) into the treadmill as shown. Make sure that the Extension Leg is turned so the Warning Decal (20) is on top. Tighten two of the four Short Screws (101) into the treadmill and the Extension Leg.

Next, tip the treadmill to the other side and attach the other Extension Leg (not shown) in the same way. Lower the side of the treadmill so that both Extension Legs

(103)are resting flat on the floor.

2.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill.

Without removing the tape from the Latch (77), attach the Latch to the left Upright (82) with two 3/4Ó Screws

(81).Make sure that the Screws are tight, but do not overtighten them; if the Screws are overtightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape.

Note: The inset drawing shows how the parts of the Latch (77) fit together.

3.Cut the plastic tie off the bracket on the base of each Upright (82).

Next, cut the plastic tie off the Left Handrail (74). Position the Left Handrail on the left Upright (82). The bracket on the base of the left Upright should be inside of the lower end of the Left Handrail, as shown in the inset drawing.

1

 

20

 

103

101

 

2

 

82

 

77

Spacer

81

 

 

Springs

 

Latch

 

Bracket

3

 

74

 

Plastic

 

Tie

 

82

82

 

 

Plastic

 

Tie

 

74

 

Bracket

5

Image 5
Contents SEARS, Roebuck and CO., Hoffman ESTATES, IL Model No Serial NoImportant Precautions Table of ContentsPage Left Side Right Side Before YOU BeginAssembly Harness into the right Upright Performant Lubetm Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord On the face of the console, remove it Key Console DiagramSTEP-BY-STEP Console Operation Insert the key fully into the consoleCALS/FAT Cals DISTANCE/LAPSInformation Mode When you are finished, remove the keyHOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USEProblem the Power does not Turn on TROUBLE-SHOOTINGProblem the Power Turns OFF During USE TopProblem The walking belt slips when walked on Problem The walking belt slows when walked onProblem The walking belt is off-center when walked on Workout Guidelines Conditioning GuidelinesExercise Intensity Key No. Qty Description Part LISTÑModel NoExploded DRAWINGÑModel No 103 104 114 108 101 115 102 107 105 100 SEARS, Roebuck and CO., Dept WA, Hoffman ESTATES, IL Full 90 DAY WarrantyModel No