Ground Wire | ProForm PFTL31105.1 specification

2.Attach a Wheel (66) to the base of the Uprights (69) with a Wheel Bolt (64) and a Wheel Nut (32) as shown. Do not overtighten the Wheel Bolt; the Wheel should turn freely.

With the help of a second person, carefully tip the tread- mill onto its other side. See assembly step 1 and attach the other Extension Leg (63) and Base Pads (57). Next, attach the other Wheel (66) as described above.

With the help of a second person, carefully tip the tread- mill so the base of the Uprights (69) is flat on the floor.

3.If there is a board between the Uprights (69), remove the board and the two bolts. Discard the board and the bolts.

Remove the tie from the Wire Harness (42). Hold one of the Handrails (71) near the right Upright (69), and insert the Wire Harness into the opening in the bottom of the Handrail and out of the indicated hole in the top.

Set the Handrail (71) on the right Upright (69), and tighten two Extension Leg Bolts (93) with two Handrail Star Washers (95) into the Handrail and the right Upright. Make sure that the Wire Harness (42) is not pinched.

Attach the other Handrail (71) to the left Upright (69) as described above. Note: There is not a wire harness on the left side.

4.Have another person hold the Console Base (47) near the right Handrail (71). There may be a green ground wire coming from the Console Base. If there is, attach the end of the ground wire to the indicated small hole in the right Handrail with the Silver Ground Screw (75).

Connect the Wire Harness (42) to the wire harness on the Console Base (47). Make sure to connect the con- nectors properly (see the inset drawing). The con- nectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE

CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.

2	64
	64
	69	66
	69
	32
3
93
	71
95	42
	69
	93
	95
	71
	69
4
	47
	75
	Ground
	Wire
	42
	71
	42